GMN SEALS – SERIES S/SA
S Design
The S design is particularly suited for use with normal spray load for rotating shafts and hubs.
Technical Data:
- Outer and inner ring: high quality Polyoxymethylene plastic
- Temperature range: -40 ° – 60 °C (special design with O-ring up to 80 °C)
- Shaft diameter: 10 – 160 mm (customized solutions available upon request)
- Width: 10, 12, 15 mm (depending on size)
- Sealing gap: Conical
- Axial play: Sax = 1 mm (total axial movement of the seals from one end position to the other)
Greased seals: All types in the S design are also available with a greased sealing gap for improved protection from dust. (Ordering designation: SdxDxB greased)
SA Design
The SA design is additionally equipped with a drainage groove on the outer ring for rotating shafts that removes any penetrated liquid during heavy and direct spray impact.
Technical Data:
- Outer and inner ring: high quality Polyoxymethylene plastic
- Temperature range: -40 ° – 60 °C (special design with O-ring up to 80 °C)
- Shaft diameter: 10 – 160 mm (customized solutions available upon request)
- Width: 10, 12, 15 mm (depending on size)
- Sealing gap: Conical
- Axial play: Sax = 1 mm (total axial movement of the seals from one end position to the other)
Greased seals: All types in the S design are also available with a greased sealing gap for improved protection from dust. (Ordering designation: SdxDxB greased)
